Surface Protection

Surface Protection — Stop Scuffs, Noise & Vibration

Keep floors, walls and equipment safe from everyday knocks and constant vibration. JACK Surface Protection products are designed to absorb impact, dampen noise and reduce vibration transfer so your home stays quieter and your surfaces last longer. Perfect for washing machines, compressors, air-con units, pipes and tight garage spaces where doors can bump walls. Explore the range and pick the format that suits your job.

Browse the full range: Surface Protection. 

Choose the Right Surface Protection

Anti-Vibration Squares – Place under washers, dryers, compressors and other kit to help cut vibration and suppress noise while protecting the floor. Available in multiple sizes.
→ Anti-Vibration Squares Jack

Anti-Vibration Pad (Roll) – Cut-to-size high-density rubber you can glue down where needed: under air-con condensers, along ducting, under lightweight machinery or along pipework to reduce rattle.
→ Anti-Vibration Pad Jack

General Protection Adhesive Foam – A fibreglass-reinforced adhesive foam roll that sticks to smooth, clean surfaces for bump protection (e.g., garage pillars as car-door bumpers) and anti-skid floor strips in tight corners.
→ General Protection Adhesive Foam 

Tip: The Home Maintenance hub summarises related solutions (tarps, gutter guard, etc.) if you’re planning a larger tidy-up.

Benefits You’ll Notice

• Less vibration & noise around appliances and machinery
• Fewer scuffs and dings on walls, pillars and floors
• Cut-to-fit flexibility (pads/foam) to suit awkward spots
• Simple DIY install with peel-and-stick or place-and-use formats
• Built for Aussie homes and everyday maintenance needs (see Advice article for use-cases).

Quick Selection Checklist

1. What’s the problem? Constant vibration/noise → choose Squares or Pad. Impact/scuffs → pick Adhesive Foam.
2. Surface type: Smooth substrates are best for adhesion (clean before applying).
3. Load/footprint: Heavier machines benefit from Squares; long runs (pipes/ducts) suit Pad.
4. Cut/shape: Need to trim around edges or pipes? Choose Pad or Adhesive Foam.
5. Environment: For outdoor/utility areas, ensure the substrate is dry and clean before install.

Practical Tips for Better Results

• Level & clean the area first to maximise contact and performance.
• For washers/dryers, centre each foot on an Anti-Vibration Square. 
• When using the Pad roll, dry-fit first, then glue in place per surface prep notes. 
• Use Adhesive Foam on door-strike zones or tight garage pillars to reduce accidental dings.

FAQs — Surface Protection

Will this stop my washing machine “walking” across the floor?
Anti-Vibration Squares help reduce movement and noise by absorbing vibration at the feet; check machine levelling too.

Can I cut the pad or foam to size?
Yes—both the Pad (roll) and Adhesive Foam are designed to be trimmed to suit and, in the case of the Pad, glued to floors or substrates where needed. 

Will adhesive foam stick to concrete?
It’s intended for smooth, clean surfaces like concrete, timber and steel; prep is essential for best adhesion. 

Is this suitable for air-conditioner units and piping?
Yes—the Pad is ideal under condensers and along ducting or pipes to reduce rattle and protect surfaces.

Where can I see all options in one place?
Visit the Surface Protection category to compare products and sizes